Troubleshooting guide

CALCULATOR

MILLPWR

Finding the Arc

Now that the lines are complete, it’s time to find the arc. Do this by selecting the lines that

have been drawn and then using GeoCalc to find the arc.

Operation Manual

6-14

• Highlight 001 GEOLINE and press the SELECT

FEATURE

softkey. The arrow indicates that the

feature has been selected.

• Now highlight 002 GEOLINE and press the

SELECT FEATURE softkey.

• Press the

FIND ARC softkey. The message bar will display a field for the arc radius.

• The print shows that the arc’s radius is 0.625. Using the keypad, enter “0.625,” and

then press the

USE key.

• Using the arrow keys, scroll through the list of found GeoArcs until the arc desired

is highlighted.

• Press the

KEEP ONE softkey, and GeoCalc will save the arc as item 003.

• Arrow down and then press the

CLEAR RESULTS softkey to erase the remaining arcs.

GeoCalc will display all of the arcs that have a 0.625 radius and are tangent with the two

lines that have been selected (A-D and B-C).