Troubleshooting guide

CALCULATOR
MILLPWR
®
Operation Manual
Starting the Program
In this example, point A is shown as datum. Its absolute coordinates are 0, 0. In the part
program, draw the line by entering the absolute coordinates for point A (0, 0) in
the “From” field and point B (2, 0) in the “To” field. Enter the Z-axis and offset infor-
mation as needed.
• Press
USE to finish programming the line.
Now use GeoCalc to find the coordinates for points C and D.
Entering the Lines
Press the
CALC key, and then press the GEOMETRY softkey. Now, press the LINE key
and construct the line from A to D.
• Press the
LINE key
• Enter the coordinates for
the “From” point (point A): X = 0, Y = 0
6-11