Troubleshooting guide

CALCULATOR
MILLPWR
®
To save your GeoCalc results onto a 3
1
/2” floppy disk:
• From GeoCalc, press the CALC FUNCTIONS softkey.
• Insert a floppy disk into the 3
1
/2” floppy disk drive.
• Press the
USE FLOPPY softkey.
• Press the
SAVE softkey.
If you’ve already saved the results from another GeoCalc session onto the 3
1
/2” floppy
disk, you will be asked if you want to replace what you previously saved. To save over the
older session, press the
YES softkey. If you don’t want to save over the older session, press
the
NO softkey. Insert a new 3
1
/2” floppy disk and repeat the procedure.
Loading GeoCalc Results That You Previously Saved
Once you’ve saved the results from GeoCalc, you can reload them into GeoCalc at
any time.
T
o load GeoCalc results into GeoCalc from MILLPWR’s internal memory:
• From GeoCalc, press the CALC FUNCTIONS softkey.
• Press the
LOAD softkey.
T
o load GeoCalc results into GeoCalc from a 3
1
/
2
” floppy disk:
• From GeoCalc, press the CALC FUNCTIONS softkey.
• Insert a 3
1
/2” floppy disk into the floppy disk drive.
• Press the
USE FLOPPY softkey.
• Press the
LOAD softkey.
Operation Manual
6-8