Troubleshooting guide

PROGRAM STEPS

MILLPWR

Operation Manual

5-63

Change Steps

The "Change Steps" feature gives you the ability to change or edit the depth, offset

and feed rate of several steps simultaneously.

Note:

You can use this feature from anywhere within your program—you don't need

to highlight a specific step within the step range.

o use the “Change Steps” feature:

• From the PGM screen, press the STEP FUNCTIONS softkey.

• Press the

CHANGE STEPS softkey.

• Enter the first and last step numbers that you would like to change in the “Step

Range” field.

• Highlight each field that you want to change and enter the new data.

• Press the

USE key.

Note:

It’s a beneficial to highlight the changed steps in the program sequence, then

press the ENTER key. Each step should include the new settings.