Troubleshooting guide

PROGRAM STEPS
MILLPWR
®
Operation Manual
5-52
• Press the
MORE STEPS softkey again.
• Press the CHAMFER softkey.
• MILLPWR will automatically fill in the "From" and “To”
fields in “Steps” for you. (Press the
CLOSE CONTOUR
softkey if you want to chamfer the end of a contour
with the beginning.)
• Enter the distance from the common point of both
lines. ("Length 1" refers to the line identified in the
"From" field; "Length 2" refers to the line identified in
the "To" field.) If you plan to use an angle, enter only
one length.
• If you entered one length above, highlight the "Angle"
field and enter the chamfer's angle from the X-axis;
otherwise, leave it blank.
• Adjust the feed rate, if necessary.
• Press the
USE key.