Troubleshooting guide

PROGRAM STEPS
MILLPWR
®
Operation Manual
5-48
• Notice that the screen is divided
into two sections—“Text Block”
and “Characters.” You can switch
from one to the other by pressing
either the
TEXT BLOCK or CHAR-
ACTER
softkey. Use the arrow keys
to move around within each section.
• In the “Character” section, high-
light a letter, number, symbol or
space. Press the
ENTER key to make
a selection. (The alphabet block on
the left side represents capital let-
ters; the block on the right side represents lowercase letters.)
To add a space, move your cursor to a blank spot anywhere within the
"Characters" box and press the
ENTER key.
You can edit text by pressing the
TEXT BLOCK softkey. Highlight the character
you want to edit, and then press one of the following:
The
CLEAR key will delete a character.
The DELETE LINE softkey will erase the entire line of text that the cursor
is in and move all following text lines up.
The
INSERT LINE softkey will insert a blank text line, moving existing
text lines down.
The
CLEAR ALL softkey will erase all of the text in the text block.
• When you’ve finished creating/editing your text, press the
EDIT TEXT softkey
(or press the
USE key) to return to the “Engrave” screen. MILLPWR will display
the text that you’ve created on the right.
• Press the
EDIT TEXT softkey if you want to make changes, or press the USE
key to add the engraving step to your program.
• Highlight a letter, number or symbol. Press the
ENTER key after each selection.
(The alphabet block on the left represents capital letters; the block on the right
represents lowercase letters.)