Troubleshooting guide

PROGRAM STEPS

MILLPWR

Operation Manual

5-43

o program a contour:

• From the PGM screen, highlight the step below the

last step in the continuous contour.

• Press the

MORE STEPS softkey.

• Press the

CONTOUR softkey.

• You’ll notice that “First” and “Last” in the “Step

Range” field will be filled in for you.

• If you wish to program an approach, press the

STRAIGHT or ARC softkey as your approach

type. Otherwise, press the NONE softkey.

Enter how far from the part you want the approach to

begin.

• To program a departure, press the

STRAIGHT or ARC softkey as

your departure type. Otherwise, press the NONE softkey.

Enter how far from the part you want your tool to travel.

• If you would like to program a finish cut, enter the amount of material to be

removed during the finish cut.

Enter the feed rate.

Using the softkeys, select the finish pass direction (

FORWARD or REVERSE).

• Press the USE key.