Troubleshooting guide

PROGRAM STEPS

MILLPWR

Operation Manual

5-25

• Enter the Z-axis feed rate.

• Enter the radius.

• For the direction, press the

CW softkey for clockwise or the CCW softkey for a counter-

clockwise direction.

• Select the appropriate tool offset.

• Enter the table’s feed rate.

• If you would like to program a finish cut, press the

softkey.

Enter the amount of material to be removed during the finish

cut.

Enter the feed rate for the finish cut.

Select the finish cut's direction. Press the

CW softkey for a

clockwise direction or the CCW softkey for a counter-clock-

wise direction.

• Press the

USE key.

Note:

If the tool size and type in the "Tool" field are incorrect, change the tool settings

before running your program (refer to Programming a Tool Step).