Troubleshooting guide

PROGRAM STEPS
MILLPWR
®
Operation Manual
5-23
• If you want to program a finish cut, press the
MORE softkey.
Enter the amount of material to be removed during the finish cut.
Enter the feed rate for the finish cut.
Select the finish cut's direction. Press the
CW softkey for a clock-
wise direction or the
CCW softkey for a counter-clockwise
direction.
Enter a stepover percentage (how much you want your tool to overlap on each pass).
• Press the USE key.
Note:
If the tool size and type listed in the "Tool" field are incorrect, change the tool settings
before running your program (refer to Programming a Tool Step).