Troubleshooting guide

PROGRAM STEPS

MILLPWR

Operation Manual

5-20

Slot

You can program a slot two ways:

• By entering the center point of each arc and the slot's width

• By entering the center point of one arc, the length and width of the slot, and an angle

Choose a method based upon the information available from your print.

To program a slot:

• Press the RECT key.

• Press the SLOT softkey.

• Enter the X- and Y-axes coordinates for the “1

Arc

Center.”

• Enter the X- and Y-axes coordinates for the “2

Arc

Center” or arrow down and enter the “Slot Length” and

“Angle.”

• Enter the begin and end depths for the Z-axis.

• Enter either the number of passes OR the distance

between each pass. “Pass” refers to the cuts that are used

to machine the pocket to its “End” depth.

• Enter the Z-axis feed rate.

• Select the direction you want your arc to be cut. Press the CW softkey for

clockwise or the CCW softkey for a counter-clockwise direction.