Troubleshooting guide

PROGRAM STEPS
MILLPWR
®
Operation Manual
5-18
Face
The “Rectangle Face” step provides a quick way to face off your workpiece.
Simply enter the coordinates from one corner and either the size of the area to be
faced off or the coordinates for a diagonal corner.
MILLPWR will position your table
at the lower left end of the area you've programmed.
T
o program a rectangle face:
• Press the RECT key.
• Press the FACE softkey.
• Enter the X- and Y-axes coordinates for the face's 1
ST
Corner.
• In the “Size” field, enter the length of the face along the
X- and Y-axes (unless you’re programming a 2
ND
Corner).
• Enter the begin and end depths for the Z-axis.
• Enter either the number of passes OR the distance between
each pass. “Pass” refers to the cuts that are used to machine
the pocket to its “End” depth.