Instructions / Assembly

4
FCC Information
This device complies with part 15 of FCC rules. Operation is subject to the following two conditions:
1- This device may NOT cause harmful interference, and
2- This device must accept any interference received, including interference that may cause undesired operation.
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications
could void the user authority to operate the equipment.
This device complies with Industry Canada licence-exempt RSS standard(s).
Setup an Alarm
1. To enter alarm SET MODE, press and release the “ ” button until “ ”
ashes. A moment later, the current HIGH alarm value will ash.
2. Press and release the “ “ or “ “ buttons to adjust the alarm’s HIGH value.
3. Press and release the “ ” button. The current LOW alarm value will be
shown.
4. Press and release the “ “ or “ “ buttons to adjust the alarm’s LOW value.
5. Press and release the “ ” button to end alarm adjustments.
Disable an Alarm
Press and release the “ ” button until “ ”is shown. You will automatically
exit alarm SET MODE if no buttons are pressed for 10 seconds. Enter alarm
SET MODE at any time by pressing the “ ” button.
Specications
TEMPERATURE RANGE
-4°F to 158°F; -20°C to 70°C
HUMIDITY RANGE
1% – 99% RH (relative humidity)
POWER
2 x AAA batteries