Instructions / Assembly

23
Problem Possible Solution
No rainfall
• Check to ensure the rain gauge stabilizer (plastic tab) has
been removed from the bottom of the sensor (see page 10).
• Clear debris, such as leaves, out of the rain collector
funnel and debris screen.
• Calibrate the Rain Gauge (see page 25).
Inaccurate wind
readings
• What is wind reading being compared to? Pro weather
stations are typically mounted at 30 ft (9 m) high or more.
Make sure to compare data using a sensor positioned at
the same mounting height.
• Check location of the sensor. Ensure it’s mounted a
minimum of 5 ft (1.5 m) in the air with no obstructions
around it (within several feet).
• Ensure wind cups are spinning freely. If they hesitate or stop
try lubricating with graphite powder or spray lubricant.
Display screen
not working
• Check that the power adapter is plugged into the
display and an electrical outlet.
• Reset the display by pressing and releasing the RESET
button, located in the battery compartment of the display.
Time and date will need to be entered after a reset.
Add-on Sensor
not recognized
If the display is being used with add-on Temperature & Humidity
Sensors (models 06002 or 06044), the A-B-C channels must differ
between each add-on sensor.
1. Bring the display and wireless sensors together and
position them side-by-side.
2. Unplug cord & remove the batteries from the display.
3. Verify that each sensor has a different A-B-C channel selected.
• Model 06002 - Locate the A-B-C switch inside the
battery compartment to adjust channel setting.
• Model 06044 - Locate the A-B-C button on the back of the
sensor to adjust channel setting (indicated on sensor display).
4. Re-install sensor batteries (if applicable).
5. Plug in & re-install display batteries.
NOTE: It may take a few minutes for the display and
sensor(s) to synchronized after batteries are replaced.
Interference
Indicator is ashing
• Relocate the lightning sensor.
• Make sure the lightning sensor is placed at least
3 feet (.9 m) away from electronics that may cause
interference (see page 14).
Troubleshooting
If your AcuRite product does not operate properly after trying
the troubleshooting steps, visit www.AcuRite.com or call
[phone] for assistance.