Specifications

Southwestern Industries, Inc.

ProtoTRAK SMX K2, K3, K4 & Retrofit Safety, Installation, Maintenance, Service & Parts List Manual

Figure 22

5.1.3 Computer Module and

LCD/Enclosure Replacement

1. Turn off power to the machine and control.

2. Unplug all the connectors on the pendant arm side of the pendant.

3. Remove the pendant from the pendant arm by removing the (4) ¼ - 20 x 3/4” SCHS

that secure it in place.

4. Place the pendant assembly on a clean and secured table with the display pointing away

from you.

5. Remove the (6) 10-32 x 3/8” Pan Phillips Head Screws and (4) 10-32 x 3/8” FHCS

securing the computer module to the LCD/enclosure.

6. Pull the computer module a few inches and stop. Pulling the computer module too far

will damage the ribbon cables.

7. Now reach from the top and remove the 37-pin LCD cable, 37-pin distribution cable and

the 9-pin E/Stop cables. The cables are to stay with the computer module.

8. Now slide the module about ½ way out of the LCD/enclosure.

9. Remove the ground wire from the LCD/enclosure side.

10. Lastly, slide the unit completely out of the LCD/enclosure.

11. Replace computer module or LCD/enclosure.

12. Follow the instructions in reverse order when reinstalling the new computer module or

LCD/enclosure.

Make sure that all connectors are properly seated before fastening the unit back in place.

Part #

Description

20201 X, Y or Z Servo Driver