Specifications

Southwestern Industries, Inc.

ProtoTRAK SMX K2, K3, K4 & Retrofit Safety, Installation, Maintenance, Service & Parts List Manual

• If the feedrate is less than 120 ipm and inconsistent in both directions, check the

incoming AC voltage and mechanics of the drive train.

4.9.2.4 CODE 123: Calibration

See Section 5.2.2 for a further explanation of this code.

4.9.2.5 CODE 127 - Set X or Y Backlash Constant

See Section 5.2.2 for a further explanation of this code.

4.9.2.6 CODE 128: Input Backlash Constant

Code 128 allows you to enter the backlash values for each axis. It displays the value after it

enters. This code is only used on machines with motor encoders only.

4.9.2.7 Code 304: Toggles X sensor or glass scale on/off

This service code toggles the X sensor or glass scale on or off. It is used to configure the

machine and also is a useful tool for troubleshooting. Code 313 (configuration file) displays

whether the sensors have been turned on or off. The line labeled secondary feedback

explains which sensors or glass scales are turned on. This line can read any one of the

following:

0 = sensors or glass scales turned off

1 = X sensor or glass scale turned on only

2 = Y sensor or glass scale turned on only

3 = both X and Y sensor or glass scale turned on

4.9.2.8 Code 305: Toggles Y sensor or glass scale on/off

This service code toggles the Y sensor or glass scale on or off. See Code 304 for further

explanation.

4.9.2.9 Code 321: Reverse Y position sensor direction

This service code reverses the direction of the encoder. It may be needed if sensors or glass

scales are mounted on different sides of the machine.

4.9.2.10 Code 322: Reverse X position sensor direction

This service code reverses the direction of the encoder. It may be needed if sensors or glass

scales are mounted on different sides of the machine.

4.9.2.11 Code 325: Reverse Quill Sensor Direction

This service code reverses the direction of the encoder.

4.9.3 Diagnostic Codes

The following codes are used primarily when diagnosing a problem with the machine. To get

to any of these codes go to Service Codes, press “C” and press the code you wish to view.

4.9.3.1 Code 54: Program Continuous Run

This Code runs a program continuously without stopping for SET Z or CHECK Z commands. It

is helpful in running a long period to identify an intermittent problem.

1. Prepare a program as you normally would.

2. Press MODE, SET UP, “C”, Code 54, INC SET. The program run will start automatically.

3. Press STOP to stop, and GO to continue.