Specifications

Southwestern Industries, Inc.
ProtoTRAK SMX K2, K3, K4 & Retrofit Safety, Installation, Maintenance, Service & Parts List Manual
34
Parts List – Figure 17, Knee Mill Lubrication
Item
P/N
Title
Qty
1
9001
HAND OILER
1
2
9002
ALUMINUM PIPE
6
3
9003
ELBOW
6
4
9004
T-JOINT - 4 HOLES- M8 X 1.0
1
5
9005
CONNECTOR
3
6
9006
REGULATING DISTRIBUTOR
1
7
9007
FLEXIBLE TUBE - 21 inches
1
8
9008
SCREW NUT - M8 X 1.0 MALE
15
9
9009
SCREW NUT - PD 1/8- 19MM
2
10
9010
SCREW - M5 X 20 mm LG
8
11
9011
SCREW NUT - M8 X 1.0 FEMALE
3
12
9012
ADAPTER
1
13
9013
SLEVE - 4.1 mm I.D.
18
i00889
2.15.2 Head Lubrication
Once Each Week:
1. Fill the oil cup on the front of the head with SAE 30 or 30 W oil. This
oil lubricates the Hi/Lo range shifter.
2. Extend the quill fully and apply a coating of SAE 30 or 30W oil to the
outside diameter of the quill.
Every Four Months:
1. Apply a good grade of general-purpose grease through the grease
fitting on the back of the head. This grease lubricates the Low-range
gear set and the feed-change gears.
2. Grease vari-disk on spindle motor through the grease fitting on the motor shaft.
2.16 ProtoTRAK SMX Euclid Block Procedure
The test part should be machined at the completion of the installation.
The material for the Euclid block test part is found in the toolbox.
• Material Specification: Aluminum, 6061-T6 or T4
• Blank Size: (minimum dimensions) 3 x 3 x 1”, provided in tool box
• Tool: .750 end mill, 2 flute, high speed steel, sharp
• Coolant: Flood coolant or Cool-Tool
1. Mount vise and indicate the back jaw parallel to the table within .0005”.
2. Clamp material in vice with a minimum of .800” above the vise jaws.
3. Load in the Euclid block program from the ProtoTRAK SMX flash disk, which is Part Number
Euclid 2 axis.PT4. It is found under the PT4 folder followed by the SWI TEST PROGRAMS
folder.
4. Use an edge finder to set Absolute 0 on X and Y. Absolute zero is the front left corner of
the block as viewed from in front of the machine.