Specifications
Southwestern Industries, Inc.
ProtoTRAK SMX K2, K3, K4 & Retrofit Safety, Installation, Maintenance, Service & Parts List Manual
10
pendant and make sure the coolant pump or solenoid for the mister fires. The accessory key
should be in the ON position to test coolant pump or solenoid. The control should be in DRO
mode. Make sure air is hooked up to the machine during the test. If the machine has a
separate coolant pump switch mounted on the pendant arm then turn this on and off to test.
27.
If the machine has a power drawbar option, check to make sure that the tools load and
unload properly. N/A to retrofits.
28.
Wipe down the machine prior to leaving.
2.5 Machine Specifications
K2
K3
K4
Movement and ranges (X, Y, Z axis) 33” x 12” x 16” 32” x 16” x 16” 32” x 16 ½” x 16.5”
Quill Travel (maximum)
5”
5”
5”
Quill Diameter 86 mm 86 mm 100 mm
Spindle Taper
R8
R8
# 40 taper
Speed Range 60-4200 RPM 60-4200 RPM 70-3950 RPM
Optional Spindle Control Speed Range Low: 40 – 600 Low: 40 – 600 Low: 40 – 600
High: 300 – 5000 High: 300 – 5000 High: 300 – 5000
Spindle to Column 8” to 20” 8” to 32” 7” to 31”
Quill Feeds Per Revolution of Spindle
(Not applicable on three axis)
.0015/.003/.006” .0015/.003/.006” .0015/.003/.006”
Head Tilt +/- 90° +/- 90° +/- 90°
Head Swivel
+/- 45
°
+/- 45
°
N/A
Spindle Motor Power 3 HP 3 HP 5 HP
Voltage
220/440 V
220/440 V
220/440 V
Machine with Optional Speed Control 220 V 220 V 220 V
Phase/Cycle
3 phase/60 Hz
3 phase/60 Hz
3 phase/60 Hz
Current- Non Spindle Control 8.5/4.3 amps 8.5/4.3 amps 14/7 amps
Current – Spindle Control
11 amps
11 amps
17.5 amps
Maximum Weight of Workpiece 750 lbs 850 lbs 850 lbs
2.6 Maximum Work Capacities
K2/K3 K4
Drilling Mild Steel (2-axis manual feed) 1 ¼” 1 ½”
Tapping Mild Steel 1” 1”
Milling (metal removal rate/mild steel) 1 ½ inch
3
/min 2 inch
3
/min
Drilling (3-axis systems) ½” ½”
Maximum work capacities are dependent on a lot of variables that cannot be controlled by the machine
manufacturer. Each one of the following will have an impact on the above numbers: speeds, feeds,
cutter, cutter sharpness, material, setup, coolant and machine adjustments. The numbers above
assume all conditions are optimal and may be higher or lower depending on material composition.