Specifications

Southwestern Industries, Inc.
ProtoTRAK SMX K2, K3, K4 & Retrofit Safety, Installation, Maintenance, Service & Parts List Manual
138
Caution!
For the X-axis, make sure the drain tube is removed from the path of the TRAK Sensor. A
crash of the sensor will break the Sensor or mounting base. Install the drain plug provided
to discourage the re-attachment of the drain tube.
7.6 TRAK Sensor Installation - Optional
See Section 5 of this manual for more sensor information.
Parts required:
• Sensor M250C
• X Y bracket kit, one of the following:
15926 16191
15927 15929
16105
7.6.1 X and Y Axis Sensor
1. Install the brackets and run bar to the machine. The bracket should position the TRAK
Sensor so that it is:
• As low as possible on the back of the table
• Does not run the gage wheel over the drain hole or any other existing holes in the
table.
• Does not run the gage wheel off the end of the table.
• Clears the machine column when the saddle is cranked all the way back and the knee
is lowered.
Figure 59
X Bracket Installation