Installation Guide

4
SETUP
PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE
WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.
BATTERY SAFETY: Clean the battery contacts and also those of the device prior to battery installation. Remove batteries from equipment that will not be
used for an extended period of time. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the device. Dispose of used
batteries properly. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fire,
as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT recharge
non-rechargeable batteries. DO NOT short-circuit the supply terminals.
Install or Replace Batteries
1. Unscrew and remove the battery compartment cover.
2. Insert 3 x AAA alkaline batteries into the battery compartment, as shown. Follow
the polarity (+/-) diagram in the battery compartment.
3. Replace the battery compartment cover and screw.
Power ON/OFF
Press and release the “ ” button to power on the anemometer.
Press and HOLD the “
” button for 3 seconds to power off the anemometer.
Alternatively, access the “POWER” screen using the “
T
“ or “ V “ button, and then
press and release the “
” button.
If there is no wind speed reading, no change in altitude greater than 5 feet, or no
buttons are pressed within 1 hour, the anemometer will automatically power off.
2
Install Batteries
3 AAA alkaline
batteries
Remove
Battery Cover
1