Service manual

© 2013 American Honda Motor Co., Inc. – All Rights Reserved. BII 13404 (1301) 5 of 30
• To prevent the clips from falling into the body
panel area, carefully insert a shop towel
between the driver’s A-pillar and the driver’s
A-pillar trim.
• Slide the driver’s A-pillar trim upward, and
remove the driver’s A-pillar trim.
• Remove the shop towel and any clips.
QB40205AJ
DRIVER’S
A-PILLAR
DRIVER’S
A-PILLAR TRIM
SHOP
TOWEL
QB40206AJ
DRIVER’S
A-PILLAR
TRIM
UPPER CLIP
8. Remove the remaining upper clip from the driver’s
A-pillar.
9. Install the new clip (supplied) to the driver’s A-pillar
trim, but do not reinstall the trim at this time.
QB40207AJ
Push
two tabs.
UPPER
CLIP
(Discard.)
DRIVER’S
A-PILLAR
QB40208AJ
DRIVER’S
A-PILLAR TRIM
CLIP
(supplied)