Service manual

© 2013 American Honda Motor Co., Inc. – All Rights Reserved. BII 13404 (1301) 3 of 30
INSTALLATION
1. Disconnect the negative cable from the battery.
2. Attach the ID label.
• Using isopropyl alcohol on a shop towel,
thoroughly clean the transmitter where the ID
label will attach.
• Attach the ID label to the transmitter in the area
as shown.
NOTE: The remote is factory set for driver 1 remote
control. To program the driver 2 remote, follow the
“Register New Transmitter” instructions on ISIS.
Client Information: The information in this installation
instruction is intended for use only by skilled
technicians who have the proper tools, equipment, and
training to correctly and safely add equipment to your
vehicle. These procedures should not be attempted by
“do-it-yourselfers.”
QB20939DH
ID LABEL
TRANSMITTER
Clean with
isopropyl
alcohol.
3. Using a plastic trim tool, remove the left and right
lenses from the front roof module (two retaining tabs
for each lens).
4. Remove the front roof module (two bolts, six
retaining tabs, and unplug the vehicle connectors).
5. Remove the driver’s and passenger’s sunvisor
holders.
QB62650AK
VEHICLE
CONNECTORS
FRONT
ROOF
MODULE
2 BOLTS
RIGHT LENS
2 RETAINING
TABS
2 RETAINING
TABS
6 RETAINING
TABS
PLASTIC
TRIM TOOL
LEFT
LENS
QB62701AK
DRIVER’S
SUNVISOR HOLDER
(Rotate.)
PASSENGER’S
SUNVISOR HOLDER
(Rotate.)