Service manual

© 2013 American Honda Motor Co., Inc. – All Rights Reserved. BII 13404 (1301) 25 of 30
84. Secure the antenna cable to the engine starter
harness with one wire tie.
85. Bundle up the excess antenna cable, and secure it
to the vehicle frame with two wire ties.
NOTE: Do not fold the antenna cable.
QB51040AH
CENTER CONSOLE
ENGINE
STARTER
HARNESS
WIRE TIE
ANTENNA
CABLE
QB51041BH
VEHICLE
FRAME
ANTENNA
CABLE
(Bundle up
the excess.)
2 WIRE
TIES
CENTER
CONSOLE
20 mm (0.8 in.)
or above.
86. Using isopropyl alcohol on a shop towel, thoroughly
clean the hood where the caution label will attach.
87. Attach the caution label to the hood in the location
shown.
88. Check that all wire harnesses are routed properly
and all connectors are plugged in.
89. Check the overlap between the headliner and the
driver’s A-pillar trim. Refer to the service manual. If
necessary, adjust the overlap.
90. Reinstall all removed parts.
91. Reconnect the negative cable to the battery.
92. Press and hold the radio power button for two
seconds to restore the radio and navi (if equipped)
system functions.
93. Reset the clock.
94. Perform the “REMOTE ENGINE STARTER
REGISTRATION” and the “FUNCTION CHECK”.
QB51042AH
Clean with
isopropyl alcohol.
CAUTION
LABEL
HOOD