Service manual

14 of 30 BII 13404 (1301) © 2013 American Honda Motor Co., Inc. – All Rights Reserved.
45. Using isopropyl alcohol on a shop towel, thoroughly
clean the relay bracket, washer nut, and cap where
the urethane tape will attach.
46. Using scissors, cut one urethane tape in half. Wrap
one halve of urethane tape around the washer nut.
QB51010AH
URETHANE TAPE
(Cut in half.)
HALVE OF
URETHANE
TAPE
RELAY
BRACKET
SECTION VIEW
WASHER
NUT
CAP
HALVE OF
URETHANE TAPE
Clean with
isopropyl
alcohol
47. Align the white tape on the engine starter harness
with the vehicle clip, and secure the engine starter
harness to the vehicle harness with one wire tie.
48. Align the other white tape on the engine starter
harness with the vehicle clip, and secure the engine
starter harness to the vehicle harness with one
additional wire tie.
QB51011AH
VEHICLE
CLIP
WIRE TIE
FRONT
VEHICLE
HARNESS
WHITE
TAPE
ENGINE STARTER
HARNESS
QB51012AH
VEHICLE
CLIPWIRE TIE
VEHICLE
HARNESS
WHITE TAPE
ENGINE STARTER
HARNESS