User guide

54
 Routing & Guidance  Edit Avoid Area
System Setup
5. Rotate i to select a method for
specifying the area. Press u.
The following options are available:
• Address: Specify the general area by entering an address.
2 Address P. 70
• Map Input: Specify the general area by map input.
2 Map Input P. 89
6. If you select Map Input, scroll the
map to position the cursor over
your desired start point, adjusting
the map scale as necessary. Press
u to mark the start point.
 To redo the area selection, press
the CANCEL button.
7. Scroll the map to “draw” the area.
Press u to mark the end point.
8. Press u to select OK.
 The area you specify is displayed
in the list of areas to avoid.
1 Edit Avoid Area
You can change the map scale to 1/4, 1/8, or
1/20 mile.
Cursor
Avoid area
RDX_KA-31TX4800.book Page 54 Monday, January 30, 2012 11:32 PM
QRG
2013 RDX Navigation