Manual

54
 Routing & Guidance  Edit Avoid Area
System Setup
5. Rotate i to select a method for
specifying the area. Press u.
• Address: Specify the general area by entering an address.
2 Address P. 70
• Map Input: Specify the general area by map input.
2 Map Input P. 88
6. Scroll the map to position the
cursor over your desired start point,
adjusting the map scale as
necessary. Press u to mark the
start point.
 To redo the area selection, press
the CANCEL button and select
an area again.
7. Scroll the map to “draw” the area
to avoid. Press u to mark the end
point.
8. Press u to select OK.
 The area you specify is displayed
in the list of areas to avoid.
Cursor
Avoid area
TSX_KA-31TL1820.book Page 54 Wednesday, September 22, 2010 3:17 PM