User's Guide

Rev. 1
HEXAPAD 10 BC USB
11.1.3 Step three. Load the firmware
The software that will be used for the firmware update will always be what is inside the folder "Acura-
SAM-BA" that was downloaded and unpacked in section 10.1.2.2 Step 2. Unpack the software
folder.
1. Inside the uncompressed folder "Acura_SAM-BA" double-click on the software
"Acura_sam-ba.exe";
2. Click "Connect";
This software will only work if you have run and installed the software "SAM-BA v2.18
NOTE:
for Windows.exe" reported in section 10.1.2.1. Step 1. Installer execution.