User's Guide

Rev. 1
HEXAPAD 10 BC USB
8.5.4.8 gen2tagencoding - EPC
Command
gen2tagencoding value
Function
Check (no value) or change the "Tag data encoding" parameter of the Gen2 pattern.
Description
It is the type of encoding of the data sent by the air by the tag.
Pattern
m4 (Miller 4)
Values
fm0
m2
m4
m8
Notes
m2, m4 and m8 can only be configured if the blf is 250 KHz.
fm0 has a low read sensitivity rate but a higher speed in the decoding of each bit.
m8 has a high read sensitivity rate but a lower speed in decoding each bit.
Example
To check the Data encoding value:
gen2tagencoding<CR>
m4<CR>
To change the value of the encoding tag to m8:
gen2tagencoding m8<CR>
ok - parameter has been changed.<CR>
Errors
When the value reported is not among the specified:
error - value out of range<CR>
When more than one value is passed to the command:
error - too many args.<CR>
When a value not supported by the already configured BLF is passed:
error - gen2 wrong parameters combination.<CR>