User's Guide

Rev. 1
HEXAPAD 10 BC USB
8.5.3 Response messages to commands
When receiving a command, the reader executes and responds with one of the following messages:
Kind
Description
Success
When the value entered is valid and different from the current value written to the reader:
ok - parameter has been changed.<CR>
When the value reported is valid and equal to the current value written to the reader:
ok - parameter already has this value.<CR>
When the facreset command is executed:
!!! Factory Reset in action !!! The reader will be restarted.<CR>
Errors
error - command not found<CR>
When a non-existent command is sent to the reader.
error - value out of range<CR>
When the value entered is not between those specified and accepted by the reader.
error - too many args.<CR>
When more than one value is passed to the command.
error - value not supported for this RF Module.<CR>
When a value is passed not supported by the RF module.
error - gen2 wrong parameters combination.<CR>
When a value not supported by the ALREADY CONFIGURED BLF is passed.
error - internal buffer full.<CR>
When the amount of characters before <CR> is greater than 50.
error - command not supported for this RF Module.<CR>
Informed command is not supported by the internal RF module.
error - command not supported for this comm interface.<CR>
Informed command is not supported by the communication interface used.