User's Guide

Rev. 1
HEXAPAD 10 BC USB
4.2 Reader firmware table
Revision
Mont
h/year
date
Descriptio
n
1.1.4
04/202
0
● New "echochar" command with "on" and "off", to turn off the
character echo via serial with the function of facilitating the
development of software that will use the commands, so if the
"echochar" is off, the software will only receive the command
response. [Autonomous Mode].
● Fixed error in the "summary" command in "gen2blf" when the "tagop"
was pa, was shown 250. [Autonomous Mode].
1.1.3
01/202
0
● New "readtag" command with "on" and "off", to turn off the rf and
turn back on in Autonomous Mode.
● New combination of Capslock (twice fast) to execute the readtag
command. [Autonomous Mode].
● Beep when running the readtag. [Autonomous Mode].
● Beep on recurrency of readmode via CapsLock. [Autonomous Mode].
● Tag read beep when readmode is serial and there is no serial
communication open. [Autonomous Mode].
● Improvement in transparent-autonomous transition and vice
versa aiming at better reader stability.
1.1.2
07/201
9
● Minor fixes and improved reader stability.
1.0.6
03/201
9
● Fixed internal communication timing error that generated reader
instability if RFON time was set to more than 500ms.
1.0.2
10/201
8
● Creation and release of the firmware.