User's Guide

Guia de usuário Edge-30R+ Autoid / Edge-30R-N+ Autoid

Rev. 13

82 de 92

13 Regional Regulations

13.1 Frequencies and operating region

When booting the Edge-30R Autoid reader, the operating frequencies (Hop-Table) are

configured according to the pre-established region in the reader firmware. For the

Brazil, the configured frequencies are:

ANATEL (Brazil) Edge-30R+ 902 to 907MHz and 915 to 928MHz

ANATEL (Brazil) Edge-30R-N 915 to 928MHz

13.2 RF reader power

For any combination of antenna and cable used with this readear, the maximum RF power

issued by the reader must be determined by means of the following equation:

max

= 36 dbm

− Antenna Gain

+ Cable Loss

The maximum configurable power on the reader is 30 dBm (for Edge-30R+) and 27 dBm (for Edge-

30R-N+).

Thus, with the antenna and cable data, the power to be configured on the readear is calculated to

its use, keeping in mind the maximums and minimums of the reader and respecting the standards

regulations of the region in which the reader is being used.

Alert:

It is the entire responsibility of the Edge 30R+ Autoid reader user to set the output RF power

correctly to comply with regional RF emission standards.

Maximum effective power (EIRP) allowed by Anatel.

Antenna gain in dBi, some specifications may provide gain in other units.

Cable loss in dB.