User's Guide

Guia de usuário Edge-30R+ Autoid / Edge-30R-N+ Autoid

Rev. 13

8 de 92

3 Introduction to equipment

Edge-30R+ and Edge-30R-N+ readers are equipment with small and high-performance Radio

Frequency Identification (UHF) RFID technology and high tag reading performance, with features and

functionality useful for vehicular access control solutions that are described throughout this document.

Below are the main features:

• Easy to use, do not require software or API/SDK, have automatic tag reading;

• They can be installed in an external area, have ip67 degree of protection, supports weather;

• Reading results are sent in real time to the PC/Controller;

• It has Wiegand communication (26/34b), Abatrack (10/14) and TCP/IP Ethernet;

• Settings via HTML page and ASCII messages via socket;

• Support up to two (2) simultaneous TCP/IP connections for receiving read data;

• Implement the "Secure Autoid System" of tag reading, where only end-user tags are read,

without reading toll tags and/or tags from other locations;

• Edge-30R+ Autoid and Edge-30R-N+ Autoid have integrated antenna with 7.5 dBic gain and

circular polarization, not being necessary rf cable installation;

• Two tag reading modes, Continuous Mode and Trigger Mode (with presence sensor);

• They have an opto-isolated digital input that accepts sensors with dry contact output, NPN and

PNP to detect the vehicle and be used in Trigger reading mode;

• Option to use a digital output using the built-in pci-embedded radio (external 24VDC source

usage required);

• They have reduced dimensions, not impacting on the aesthetics of the installation site;

• Contains tag signal level filter setting (RSSI), which helps filter unwanted tag readings.

The PCI Interface is a board that facilitates connections between the customer controller and the

through an RJ45 communication cable. Below are the main features

of the PCI Interface.

• It has RJ45 connectors and post type;

• It has small dimensions and can be fixed on DIN rail.