User's Guide

Guia de usuário Edge-30R+ Autoid / Edge-30R-N+ Autoid
Rev. 13
Copyright © 2022 Acura Technologies
74 de 92
$ SET OUTPUT0=~<CR>
Host →
Reader
Host sends the message to reverse
the logical state of the l.A.
$ OK<CR>
Host ← Reader
Reader responds with OK.
$ SET OUTPUT0=*<CR>
Host →
Reader
Host sends the message to trigger
the laser's pulse.
$ OK<CR>
Host ← Reader
Reader responds with OK.
Configuring GPIO (continued):
INITOUTPUT0
INITOUTPUT1
SET/GET
Individually changes or checks the initial logical state of OUTPUT0 to (W0/CLK)
and OUTPUT1 to (W1/DATA). Values [0 or 1].
Note: Note: You do not need to reboot the reader.
Note: The initial logical state refers to the output state at reader startup.
Example:
Direction
Description
$ SET INITOUTPUT0=1<CR>
Host → Reader
Host sends the message to configure the
initial logical state of the OUT0 output.
$ OK<CR>
Host ← Reader
Reader responds with OK.
10.3.11 Miscellaneous settings
RSTRDR
Command to reboot the reader, some settings require the reader to restart.
Example:
Direction
Description
$ RSTRDR<CR>
Host → Reader
Host sends the message to restart the
reader.
$ OK<CR>
Host ← Reader
Reader responds with OK and then
reboots.
REGION
GET
Checks the region of operation (frequencies and regulations) that was recorded at
the factory for the operation of the reader.
Example:
Direction
Description
$ GET REGION<CR>
Host → Reader
Host sends the message to check what
the operation region is. Reader
responds with the Region of Brazil and
Anatel regulations are being used.
$ BR (ANATEL)<CR>
Host ← Reader
Reader responds with the Region
of Brazil and Anatel regulations are
being used.