User's Guide

Guia de usuário Edge-30R+ Autoid / Edge-30R-N+ Autoid
Rev. 13
Copyright © 2022 Acura Technologies
68 de 92
FTRSSI
SET/GET
Changes or checks the filter value by signal level (RSSI). Values from 20 to 99 dbm
are allowed, leaving the value empty disables the filter.
Note: You do not need to reboot the reader.
Example:
Direction
Description
$ GET FTRSSI<CR>
Host →
Reader
Host sends the message to read the rssi
filter value.
$ 50<CR>
Host ← Reader
Reader replies that the value is -50dBm.
$ SET FTRSSI=<CR>
Host →
Reader
Host sends the message to change the
value to empty, disabling the filter by
RSSI.
$ OK<CR>
Host ← Reader
Reader responds with OK.
DELAYTX
SET/GET
Time between transmission of ids read at the same time.
Note: You do not need to reboot the reader.
Note: Time used only when more than one tag is read at the same time.
Example:
Direction
Description
$ GET DELAYTX<CR>
Host →
Reader
Host sends the message to read the
broadcast value of ids.
$ 200<CR>
Host ← Leitor
Reader responds that the value is 200.
$ SET DELAYTX=200<CR>
Host →
Reader
Host sends the message to change the
transmission value of read ids to 200.
$ OK<CR>
Host ← Reader
Leitor responde com OK.
Setting Reading (continued):
SNDOPT
SET/GET
Changes or verifies which Id should be sent by the communication interface when a
vehicular tag associated with a personal tag is identified and approved. [VEHICLE]
values to send vehicle tag Id, [DRIVER] to send Driver Tag Id, and [BOTH] to send
the two Ids, first from the vehicle and then from the driver.
Note: You do not need to reboot the reader.
Note: Parameter used only when the autoid system type is secure.
Example:
Direction
Description
$ GET SNDOPT<CR>
Host →
Reader
Host sends the message to check
which id should be sent in case of
membership.
$ VEHICLE<CR>
Host ← Reader
Reader responds with the vehicular tag
id.