User's Guide

Guia de usuário Edge-30R+ Autoid / Edge-30R-N+ Autoid
Rev. 13
Copyright © 2022 Acura Technologies
67 de 92
RDTMTRG
SET/GET
Changes or checks the time, in seconds, of the read trigger. Values from 1 to 600s
are allowed.
Note: You do not need to reboot the reader.
Note: Parameter used only when read mode is Trigger.
Example:
Direction
Description
$ SET RDTMTRG=10<CR>
Host →
Reader
Host sends the message to change the
value to read 10s after the trigger signal.
$ OK<CR>
Host ← Reader
The reader returns OK.
$ SET RDTMTRG=0<CR>
Host →
Reader
Host sends the message to change the
value to 0s.
$ ERROR<CR>
Host ← Reader
The reader returns Error because the
past value is outside the allowed range.
FTSMTG
SET/GET
Changes or checks the time, in seconds, filtering the same tag. Values from 0 to
600s are allowed.
Note: You do not need to reboot the reader.
Example:
Direction
Description
$ GET FTSMTG<CR>
Host →
Reader
Host sends the message to read the time
value of the same tag filter.
$ 1<CR>
Host ← Reader
Reader replies that the value is 1s.
$ SET FTSMTG=0<CR>
Host →
Reader
Host sends the message to change the
value to 0s, that is, no filter.
$ OK<CR>
Host ← Reader
Reader responds with OK.
Setting Reading (continued):
RDPOWER
SET/GET
Changes or checks the value of the reading power in centidBm. Values from 500 to
3000 centidBm are allowed.
Note: You do not need to reboot the reader.
.
Example:
Direction
Description
$ GET RDPOWER<CR>
Host →
Reader
Host sends the message to read the read
power value.
$ 3000<CR>
Host ← Reader
Reader responds that the value is
30dBm.
$ SET RDPOWER=1000<CR>
Host →
Reader
Host sends the message to change the
value of 10dBm.
$ OK<CR>
Host ← Reader
Leitor responde com OK.