User's Guide

Guia de usuário Edge-30R+ Autoid / Edge-30R-N+ Autoid
Rev. 13
Copyright © 2022 Acura Technologies
65 de 92
$ SET SYSLGADDR=192..168.0.84<CR>
Host →
Reader
Host sends the message to
change the IP address of
the Syslog server.
$ ERROR<CR>
Host ← Reader
Reader responds with error
because the address
format was incorrect.
$ SET SYSLGADDR=192.168.0.84<CR>
Host →
Reader
Host sends the message to
change the IP address of
the Syslog server.
$ OK<CR>
Host ← Reader
Leitor responde com OK.
Network Configuration (continued):
DTPORT
CFPORT
SET/GET
Changes or verifies the tcp communication port number [DTPORT] and the
configuration TCP port number [CFPORT]. Values from 1000 to 65535.
Note: You do not need to reboot the reader.
Note: If there is already a connection established at the time of changing tcp ports, the new value will
only be used by the reader on the next connection attempt, the existing connection will not be affected.
Example:
Direction
Description
$ GET DTPORT<CR>
Host →
Reader
Host sends the message to check the
value of the TCP communication port of
the tag read results.
$ 8080<CR>
Host ← Reader
Reader responds with the value of the
TCP port.
$ SET DTPORT=8888<CR>
Host →
Reader
Host sends the message to change the
value of the TCP communication port.
$ OK<CR>
Host ← Reader
Reader replies that the change was
successful.
$ GET PORT<CR>
Host →
Reader
Host sends the message to read the
value of the TCP port configuration.
$ 9090<CR>
Host ← Reader
Reader returns the value of the TCP port.