User's Guide

Guia de usuário Edge-30R+ Autoid / Edge-30R-N+ Autoid
Rev. 13
Copyright © 2022 Acura Technologies
63 de 92
Exemplo:
Direction
Description
$ GET AUTOID<CR>
Host → Reader
Host sends message to check which
Autoid System is running.
$ NORMAL<CR>
Host ← Reader
Reader replies that it is Autoid
Normal.
$ SET AUTOID=SECURE<CR>
Host → Reader
Host sends message to change the
Autoid System to Safe mode.
$ OK<CR>
Host ← Reader
Reader responds with OK.
10.3.7 Setting Up Network
IPADDR
MKADDR
GWADDR
SET/GET
Changes or verifies the IP address of the reader [IPadDR], the network mask
[MKADDR] and the gateway address [GWADDR], the addresses must be in IPv4
format.
Note: You must reset the reader after changing these parameters by sending the message with the
restart command "$ RSTRDR<CR>".
Example:
Direction
Description
$ GET MKADDR<CR>
Host →
Reader
Host sends the message to
check the network mask.
$ 255.255.255.0<CR>
Host ← Reader
Reader responds with the
mask value.
$ SET IPADDR=192.168.1.100<CR>
Host →
Reader
Host sends the message to
change the IP address.
$ OK<CR>
Host ← Reader
Reader responds OK, address
changed.
$ SET GWADDR=192.168.1.2<CR>
Host →
Reader
Host sends the message to
change the address of the
gateway.
$ OK<CR>
Host ← Reader
Reader responds with OK,
address changed.
$ RSTRDR<CR>
Host →
Reader
Host envia a mensagem para
reinicializar o leitor para que
as alterações.
$ OK<CR>
Host ← Reader
Reader responds with OK.
DNS1ADDR
SET/GET
Changes or verifies the IP address of the DNS server that will be queried by the
reader to resolve names.
Note: You do not need to reboot the reader.