User's Guide

Guia de usuário Edge-30R+ Autoid / Edge-30R-N+ Autoid
Rev. 13
Copyright © 2022 Acura Technologies
54 de 92
Communication Parameters:
Parameter
Description
Type
communication
interface
Reading results are made available through the Wiegand or Abatrack
communication interfaces, and simultaneously through tcp/IP Ethernet
interfaces.
You can use the two signal lines (W0/CLK) and (W1/DATA) as digital outputs,
selected None(GPO), thereby disabling Wiegand and Abatrack communications.
Note: TCPIP communications are always active, in parallel to the interface
chosen here.
Factory setup: Wiegand.
Number of
wiegand bits
Number of bits of the entire packet transmitted in Wiegand format.
26 bits: Format: Parity[1bit] + Data[24bits] + Parity[1bit].
34 bits: Format: Parity[1bit] + Data[32bits] + Parity[1bit].
Note: Parameter used only when the "Communication interface type" is
"Wiegand".
Factory configuration: 26 bits.
Number of
abatrack digits
Number of digits in decimal in Abatrack format.
10 dig. : The reader sends 10 digits in decimal on the Abatrack interface.
14 dig. : The reader sends 14 digits in decimal on the Abatrack interface.
Note: Parameter used only when the "Communication interface type" is
"Abatrack".
Factory configuration: 10 dig.
Data String
It is the string that the reader will transmit only through the Ethernet interface at
each tag reading. The keywords below will be replaced by their respective
values:
Keyword
Description
Size
characters
IDHEX
Tag ID in hexadecimal format.
* Variable size for Normal Autoid and 8-character size for
Autoid Insurance.
*
IDWG
Tag ID in Wiegand26 format "FC[3dig.] ID[5dig.]".
08
IDABA
Tag ID in abatrack (decimal) format "ID[10dig.]".
10
RDCT
Number of tag reads for each inventory.
02
RSSI
Value of the signal level (negative) that the tag reported.
03
ANTID
Number of the antenna on which the tag was read.
01
TMSTP
Timestamp [dd-mm-aaaa hh:mm:ss] of reading.
19