User's Guide

Guia de usuário Edge-30R+ Autoid / Edge-30R-N+ Autoid

Rev. 13

52 de 92

Read parameters (continued):

Parameter

Description

Reading power

Power in centidBm (dBm / 100) referring to tag reading.

The read power can be adjusted to change the read region of tags at the

installation location.

Factory configuration: 3000dBm | Values: 500 to 3000 centidBm (5 to

30 dBm).

Filter by tag signal level

The signal level of the tag indicates whether the tag is near or away from

the antenna, when closer to the antenna, the stronger the RSSI (closer to

zero) and vice versa. If a value is specified for the filter, only tags with RSSI

equal to or greater than that specified will be reported by the reader.

The signal level of the tag is measured in dBm and is a negative value, the

power in Watts is always less than 1mW.

Note: To disable the filter, simply leave the field empty.

Note: The specified value should not contain the minus sign.

Factory setting: Empty (filter disabled) | Values: 20 to 99|dBm| (-20 to -

99dBm).

Filter by reading

tags that contain

on your id the mask

Is the mask value that the tag id must contain to be read, if this field

contains some value, the reader will read only tags that contain this mask

from the given digit.

Note: Parameter used only when the "Autoid System Type" is "Normal or

Hybrid".

Factory configuration: empty, unfiltered | Values: hexadecimals max.

24 digits.

Initial digit of the

mask in tag ID

Is the starting digit in which the mask provided above starts in the tag id.

Note: Parameter used only when the "Autoid System Type" is "Normal or

Hybrid".

Factory configuration: 0 | Values: 0 to 24.