User's Guide

Guia de usuário Edge-30R+ Autoid / Edge-30R-N+ Autoid

Rev. 13

51 de 92

10.2.4 Setting Up Reading

1. After login, click Read.

1. Change the parameters.

2. Click Apply to save the changes.

3. If you see the message prompting you to restart the reader, click Restart.

Reading Parameters:

Parâmetro

Descrição

Reading Mode

Read operation mode that will be performed by the reader.

Continuous mode: Operation mode where the reader performs read

operations continuously.

Trigger mode: Operation mode where the reader performs read operations

only when it receives a signal from a sensor through its digital input.

Factory Setup: Continuous Mode

Trigger reading time

It is the time in seconds that after a trigger signal on the digital input (ISO

IN), the reader performs an inventory operation (tag reading).

Note: Parameter used only when "Read mode" is "Trigger Mode".

Factory configuration: 1s | Values: 1 to 600s.

Filter time of the same

tag

Is the time in seconds of the read filter of the same tag, that is, the tag id is

sent to the PC/Controller on the first read and resent only after the time

configured in this field.

Factory configuration: 1s | Values: 0 to 600s.