User's Guide

Guia de usuário Edge-30R+ Autoid / Edge-30R-N+ Autoid

Rev. 13

43 de 92

10 Configuring the Readear

10.1 Reader IP address

Readers (firmware 2.1.6 or above) with factory settings automatically generates their IP address using

the default Range of Local Link Address IPV4 169.254.0.0/16.

Readers use the following logic for generating their IP when they have factory settings:

IP = 169,254. xx. xx where xx are the last two decimal digits of the reader's MAC address, for example,

MAC = 0.36.119.82. Five, five of them. 38 your generated IP will be 169,254. Five, five of them. 38, if

this same IP exists on the same local network as the reader, the fixed IP 10.0.0.101 will be used by the

reader (very low probability).

Ways to get the READER MAC address:

1. External label on the side of the reader

NOTE:

Due to the weather the label on the side of the reader may become unreadable, it is

recommended to write this data right at the beginning of the installation.

2. Software Device Explorer (Windows)

Download: Device Explorer

Click Refresh to see all readers on the local network.

NOTE:

UDP 65535 port must be released in operating system firewall rules.