User's Guide

Guia de usuário Edge-30R+ Autoid / Edge-30R-N+ Autoid

Rev. 13

37 de 92

NOTICE:

For digital input, use the "ISO_GND" pin for sensors with Dry Contact

output and use the "ISO_COM" pin for sensors with wet contact output

in any polarity.

8.7 Electrical connections - Relé

Built into the PCI, the reader itself can send a digital signal through the handover. To use the digital

outputs, the relay is required to power with an external 24 VDC source (not supplied, but may be the

same as that used in the Edge-30R Autoid).

A saída digital do leitor possui as seguintes características elétricas:

• 1KV RMS Opto-Isolated Output;

• High Level (24V), triggered via ethernet command, example "$ SET OUTPUT0=1<cr>";

• Low Level (0VDC), triggered via ethernet command, example "$ SET OUTPUT0=0<cr>";

The digital outputs can be accessed through the "RELAY" connector of the PCI Interface card, below

follows the descriptions of the signals of the digital outputs.

Below is image informing the Contacts of the Relé on PCI.

PCI Connector

Pino

Function

Relay

RL+

Power Relay

RL-

GND Relay

RL_NC

Normal Contact Closed

RL_CM

Common Contact

RL_NO

Open Normal Contact

NOTA:

It is necessary to use an external 24VDC source (not supplied). Can be the same as used in

EDGE 30R Autoid

COM