User manual

AcuPanel 12 User Manual
2.2.3. Switching on the power
The Power button is found on the left bottom on the rear side of the Panel PC. Press the Power button to start AcuPanel12 and check that the
Power LED lights on to green on the front panel.
Chapter 3 Using the Panel PC
AcuPanel12 is designed and pre-configured for easy setup and use. This chapter describes the installation steps you should follow to get the
system up and running as quickly as possible.
3.1 Using the USB Mouse and Keyboard
To install a full-size desktop keyboard and mouse with the panel PC, please follow the instructions below:
1. Turn off the panel PC.
2. Attach the USB keyboard and mouse to the USB ports.
3. Turn on the panel PC.
3.2 Using the Serial Ports (COM)
There are two serial COM ports on the bottom. It is simple to attach a serial device to the panel PC, like an external modem or mouse. Please
follow these instructions below for connecting :
1. Be sure the panel PC and any other peripheral devices that are connected to the panel PC are turned off.
2. Attach the interface cable of the serial device to the panel PC's serial port. If necessary, attach the other end of the interface cable to the
serial device. Fasten any retaining screws.
11