User`s manual

ACUBRITE™ 23 SS Manual ACUBRITE™ 23 SS Manual
Introduction
Welcome to enjoy the fantastic sightseeing world. This new technology will bring you
the whole new feeling about the “monitor”. We show here some of the major
advantages of the LCD monitor. You will really find some other advantages when you
use it.
Hardware Installation
This chapter will guide you the correct installation procedures of your LCD monitor.
Unpacking
After you unpack your LCD Monitor, please make sure that the following items are
included in the carton and in good condition. If you find that any of these items are
damaged or missing, please contact your dealer immediately.
One LCD Monitor
15-pin D-sub VGA cable
AC/DC adapter with 12V DC output & AC power cord
Remote Control
TV Tuner (Option)
Installation
This analog LCD display does not require any special drivers. Necessary drivers are
supplied by the video card manufacturer and may be found on the diskettes supplied
with the video card that came with your computer. Windows 98/2000/XP drivers for
both the display and the video card are supplied on the Windows 98/2000/XP CD or
diskettes. Unfortunately, Microsoft did not provide a complete listing of the displays on
the initial retail release. You may use the standard XGA (1024x768) as the display type.
The video card must also be set up correctly in Windows 98/2000/XP and make sure
the video output of the VGA card is on list in Section 6.1 or check your Video Card
manual or Windows 98/2000/XP Read me file for further information on Video Card.
After the question listed above is solved, we continue the setup procedure as below.
1. Turn power off both Computer and Display before making any connection.
2. Install Display on the solid horizontal surface such as a table or desk.
3. Connect the power cable and the AC/DC adapter, then connect adapter
toe the back of the LCD monitor.
4. The LCD monitor comes with a 15-pin video cable; you may use this cable
for both IBM PC’s & compatibles and Macintosh.
5. Tighten the screws of the Display cable until the connectors are fastened
securely.
6. Switch on power to the Computer system, then to the monitor.
Page 2
The following picture provides the connection outline
VGA Input Pin Assignment
This section describes the pin assignment of the LCD’s VGA connector. It is called
15pin Mini D-sub connector.
Page 3