Specifications

Specifications SDR2-CF/SDR2-OEM-CF Configuration Guide rev 1.0
59
NOTE: The SDR2-CF
datasheet contains
further specifications.
All specifications
shown in this section
may be superseded by
the datasheet.
B
B
B.Specifications
B.1 Electrical specifications
SDR2-CF requires a 5 to 30 VDC power source or a regulated +5VDC
power source (SDR2-OEM-CF). Connectors J7 and J1 are present on both
the SDR2-CF and SDR2-OEM-CF. J1 is inaccessible on the SDR2-CF
without removing the enclosure.
Recording Mode +10 VDC
see data
sheet
Idle +10 VDC
Recording in Low Power Mode +10 VDC
Idle in Low Power Mode +10 VDC
Table B.1. DataBridge SDR2-CF power consumption with
CompactFlash card installed.
B.1.5 J7 rear power receptacle pin configuration
pin Function
Tip +5 to +30 VDC
ring Ground
Table B.2. The SDR2-CF/SDR2-OEM-CF rear power receptacle
pin configuration.