Specifications

Configuring the DataBridge SDR2-CF SDR2-CF/SDR2-OEM-CF Configuration Guide rev 1.0

Messages are stored as ASCII text strings in non-volatile memory. To use

messages, first enter a text string for one of the ten messages. Then,

configure whether the message should be sent on when recording starts,

when recording stops, or at an interval specified in seconds. The SDR2-CF

can also be configured to append a carriage return

<CR> and/or line feed

<LF> to any message.

To enter a new message, type 5 at the main menu prompt to enter the Edit

Messages submenu. To edit a message, type 1. When prompted, enter the

desired message number (0-9) and type a message followed by the

<Enter> key

Figure 2.10. Changing message zero to “$1RD”.

Setting message parameters

To change a message’s parameters, type 2 at the menu prompt. When

prompted, enter the desired message number (0-9) and type a message

followed by the <Enter> key

Output intervals: The SDR2-CF sends a message, then waits a specific

amount of time before sending the message again. When configuring a

message, you are prompted to enter this period, or output interval. For

instance, if the message should be output once every ten seconds, type 10

and press the <Enter> key. To disable a message (but leave its contents

intact), enter 0.