ACUMEN Acumen Wall Mount Remote (2 Hours) Fireplace Remote Control installation and Operation Instructions: The Acumen Wall Mount Remote Control is designed for use with decorative gas fireplace and wall heaters using SIT 852 Nova gas valve The Wall Mount Transmitter is a two-button wall mount transmitter, which tum the gas on/off. The display of the transmitter shows the current room temperature and fow battery indicator.
WARNING: TURN ELECTRICAL POWER OFF AT THE CIRCUIT BEAKER BEFORE BEGINNING THIS INSTALLATION. 1. Make sure the slide switch on the Remote Receiver is at the OFF position. See Figure 1. Remote pT} Main Receiver Burner Millionth Generator le=] Figure 1 Figure 2 2. Connect the leads to the millionth generator and the main burner to the output cable of the Remote Receiver as shown in Figure 2. 3. Installing the Remote Receiver to a Fireplace: Secure the Fireplace Mounting plate to the base pan of the fireplace.
2.0 Operation Instructions: 2.1 Transmitter Operation A. Flame On/Off 1. Press the Start button once to start the 2 hour timer and turn on the fireplace. 2. Press the Off button once to turn off the fireplace. WARNING: IT TAKES SOME TIME FOR THE RECEIVER TO RESPOND TO THE TRANSMITTER.DO NOT PRESS THE MANUAL AND / OR AUTO ON/OFF BUTTONS MORE THAN ONCE WITH 2 SECONDS FOR CORRECT OPERATION. B. °F/°C Selection 1 Press and hood the OFf button for finger than 4 seconds. The °F or °C display will blink. 2.
Press a bunion on the Remote Transmitter. The Remote Receiver will produce & ‘beep’ sound whiny it” receives the code from the Remote Transmitter. if you do not hear a "beep’ sound from the Remote Receiver, removes batteries from the Remote Transmitter, wait for 1 minute, and repeat step to 5, Replace the cover of the Remote Transmitter and the Receiver. The system is now ready tc operate.
