ACUMEN EN aT Fireplace Senate Control Installation and Operation Instructions: The Acumen NEONATAL Remote Control is designed for use with decorative gas fireplace and wall heaters using SIT: 825 Nova gas valve. The NEONATAL Transmitter is an eight-button hand held transmitter, which turn the gas on/off or asa thermostat, adjust the flame height, and tum the blower on/off and adjust its speed to Hi-Medium-Low.
All wiring should bie done by a qualified electrician and shall be in compliance with local codes and with the National Electric: Code EXPANSION No. 70-current (In the United States). or with the current CSA C291 Canadian Elective Code (in Canada). 1.0 Installation Instruction 1.1 Installing the Receiver WARNING: TURN ELECTRICAL POWER OFF AT THE CIRCUIT BEAKER BEFORE BEGINNING THIS INSTALLATION. 1. Connect the electrical service wires to the junction box of the fireplace. 2.
on and he gas valve control is in the "ON position: Figure 4 1.2 Installing the Charger 1. Plug the power cord of the Charger to a wall socket: 2. Put the Remote Transmitter onto the Charger whenever if is riot in Use in order to keep the rechargeable batteries inside fully charged. 2.
Remove the cover at the hack of the Remote Transmitter 10 expose the CHILD-PROOF switch: Slide the CHILD-PROOF switch to position marked C/P to activate the CHILD-PROSE function Chided-Proof ¥ will appear on the LCD. See Figs: In CHILD-PROOF the Remote Transmitter will not operate the Remote Receiver int ihe “child proof’ code is used or the switch is returned to the other position.
Press a bison on the Remote Transmitter. The Remote Receiver will produce: a beep” sound when it receives the code from the Remote: Transmitter: if: you do not hear a ‘beep’ sound from the Remote Receiver, removes batteries from the: Remote Transmitter and power from the Remote Receiver, Wail for 1 minute and repeat step 3 to 6. Replace the cover of the Remote Transmitter and the Receiver. The system is no ready fo operate.
