ACUMEN Acumen EON Fireplace Remote Control Installation and Operation Instructions: The Acumen EON Remote Control is designed for use with decorative gas fireplace and wall heaters using SIT 825 Nova gas valve. The EON Transmitter is an eight-button hand held transmitter, which turn the gas on/off or as a thermostat, adjust the flame height, and turn the blower on/off and adjust its speed to Hi-Medium-Low.
All wiring should be done by a qualified electrician and shall be in compliance with local codes and with the National Electric Code ANSHAN No. 70-current (In the United States), or with the current CSA C22.1 Canadian Electric Code {in Canada). 1.6 Installation Instruction 1.1 Installing the Receiver WARNING: TURN ELECTRICAL POWER OFF AT THE CIRCUIT BEAKER BEFORE BEGINNING THIS INSTALLATION. 1. Connect the electrical service wires to the junction box of the fireplace. 2.
2.0 Operation Instructions: The EON Remote Control has 5 operating modes. They are: Manual, Auto, Timer, Flame Adjustment and Fan Adjustment You can only operate the Flame Adjustment and Fan modes in Manual or Auto Modes. Use the Up and Down buttons to set the target temperature between 45°F and and 32°F. 2.1 Operating Modes : A. Manual Mode: Press the Manual On/Off button once to light the fireplace. Push the button again to turn it off.
3.0 the Remote Transmitter to display temperature Press the clock button again to exit setting. Batteries The Remote Transmitter uses 3 AAA-size batteries. Replace these batteries at least every 6 months or when the Low battery indicator on the LCD is on. After you take out the batteries, wait for at least 1 minute before putting fresh batteries into the Remote Transmitter. Use fresh alkaline batteries only.
