User's Manual

You can set a private code into your system to prevent accidental operation by another transmitter nearby.
3.1 Coding Instructions:
1. Slide the code switches at the back of the Remote Transmitter to you choice of ON or OFF positions.
FACTORY SETTING IS ALL ”OFF”.
2. Remove power from the Remote Receiver by unplugging the power cord or power off at the circuit
breaker.
3. Take the Remote Transmitter close to the fireplace or the Remote Receiver (less than 5 feet from the
fireplace or Remote Receiver is recommended.)
4. Powering-up the Remote Receiver.
5. Install fresh AAA alkaline batteries into the Remote Transmitter. The LCD on the Remote Transmitter will
blink.
6. Press a button on the Remote Transmitter. The Remote Receiver will produce a ‘beep’ sound when it
receives the code from the Remote Transmitter.
7. If you do not hear a ‘beep’ sound from the Remote Receiver, removes batteries from the Remote
Transmitter and power from the Remote Receiver. Wait for 1 minute and repeat step 3 to 6.
8. Replace the cover of the Remote Transmitter and the Receiver. The system is now ready to operate.
9. If you desire to operate multiple Remote Receivers with the one Remote Transmitter, continue to hold
the button on the Remote Transmitter as you bring the Remote Transmitter within 5 feet of each Remote
Receiver then slide the switch on the Remote Receivers to ON position. Each will acknowledge receipt
of coding with a beep.