User's Manual

Use the Up and Down buttons to set the target temperature between 45
o
F and 90
o
F, or 8
o
F and 32
o
F.
2.1 Operating Modes :
A. Manual Mode:
1. Press the Manual On/Off button once to light the fireplace. Push the button again to turn it off.
2. In Manual mode the Remote Transmitter will not turn the fireplace off even if the room temperature
exceeds the target temperature.
3. The fireplace will automatic turn off after 6 hours.
B. Auto Mode:
1. Set the desired target temperature.
2. Press the Auto On/Off button once to activate the Auto mode. In Auto Mode the Remote Transmitter will
automatically turn on the fireplace when the room temperature is below the target temperature and turn
off the fireplace when the room temperature is above the target temperature.
3. Press Auto On/Off button or Manual On/Off buttons to turn off the fireplace (if it is already on) and exit
Auto Mode.
WARNING: IT TAKES SOME TIME FOR THE RECEIVER TO RESPOND TO THE TRANSMITTER.DO NOT
PRESS THE MANUAL AND / OR AUTO ON/OFF BUTTONS MORE THAN ONCE WITH 2 SECONDS FOR
CORRECT OPERATION.
C. Timer Mode:
1. You can set the timer to the length of time you want the fireplace to operate (1 to 120 minutes).
2. Press the ”TMER” button once. The Timer display “----“ will blink.
3. Press the Up and Down buttons to set the timer. The LCD will display the time chosen.
4. The timer setting can be cancelled at any time by press and hold the ”TIMER” button.
5. Press Manual or Auto On/Off button to turn on the fireplace.
6. The fireplace will turn off at the end of the timer setting.
D. Child-Proof Function :
1. Remove the cover at the back of the Remote Transmitter to expose the CHILD-PROOF switch.
2. Slide the CHILD-PROOF switch to position marked C/P to activate the CHILD-PROOF function
“*Child-Proof *” will appear on the LCD. See Fig 4.
3. In CHILD-PROOF the Remote Transmitter will not operate the Remote Receiver until the “child-proof”
code is used or the switch is returned to the other position.
4. Press the Up and Down buttons in the following sequence, Up-Down-Down-Up-Down, within 2 seconds
button function will be temporarily restored, “*Child-Proof*” will disappear from the LCD.
5. If no button is pressed within 2 minutes, the Remote Transmitter will return to Child-Proof function and
“*Child-Proof*” will reappear on the LCD until the Child-Proof switch is slide back to the other position.
E. Settings :
1. Press and hold clock button for about 2 seconds.
2. The hour display will flash. Use the Up and Down buttons to set the hour.
3. Pres the clock button again and the minute display will flash. Use the Up and Down buttons to set the
minutes.
4. Press the clock button again and the °F or °C display will flash. Use the Up and Down button to select
the Remote Transmitter to display temperature in °F or °C.
5. Press the clock button again to exit setting.
F. Batteries
1. The Remote Transmitter uses 3 AAA-size batteries. Replace these batteries at least every 6 months or
when the Low battery indicator on the LCD is on.
2. After you take out the batteries, wait for at least 1 minute before putting fresh batteries into the Remote
Transmitter.
3. Use fresh alkaline batteries only.
3.0 IMPORTANT SAFETY FEATURE: